1 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors iec appliance inlet c14 or c18 with circuit breaker ta35 2-pole screw-on with ip67 and ta35 in white with black printed symbols screw-on with ip67 snap-in ip40 with ta35 red illuminated and em - bossed symbols see below: approvals and compliances c14 70 c c18 70 c description - panel mount : screw-on version from front or rear side, snap-in version from front side - 2 functions : appliance inlet , protection class i or ii , circuit breaker type ta35 , 2-pole - pre-wired coupling - v-lock notch standard - quick connect terminal 6.3 x 0.8 mm unique selling proposition - variant tested for ip67 into the appliance - various mounting options - recessed rocker prevents accidental manipulation - compatible with v-lock cord retention characteristics - connector and circuit breaker are prewired - circuit breaker non-illuminated or illuminated - suitable for use in equipment according to iec/ul 60950 other versions on request - version without pre-wiring from inlet to circuit breaker - protection class ii, 70c - variants in white references substitute for type 6135 component: circuit breakers ta35 rocker 2pole weblinks pdf datasheet, html-datasheet, general product information, distributor- stock-check, accessories, detailed request for product, microsite technical data ratings iec 10 a / 250 vac; 50 hz ratings ul/csa 15 a / 250 vac; 60 hz dielectric strength > 2.5 kvac between l-n > 3 kvac between l/n-pe (1 min/50 hz) allowable operation tempe - rature -25 c to 60 c ip-protection from front side ip40 or ip67 acc. to iec 60529 insulation cover suitable for appliances with protection class i or ii acc. to iec 61140 terminal quick connect terminals 6.3 x 0.8 mm panel thickness s screw: max 8 mm recommended torque min 0.25 nm snap-in : s =1/1.2/1.5/2/2.5/3 mm material: housing thermoplastic, black, ul 94v-0 appliance inlet/-outlet c14 / c18 acc. to iec 60320-1 ul 60320-1, csa c22.2 no. 60320-1 (for cold conditions) pin-temperature 70 c, 10 a, protection class i or ii circuit breakers acc. iec/en 60934, ul 1077, csa 22.2 no. 235 2-pole rocker switch, illuminated or non- illuminated. conditional short circuit inc: 2000 a approvals and compliances detailed information on product approvals, code requirements, usage instructions and detailed test conditions can be looked up in details about approvals
2 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors approvals the approval mark is used by the testing authorities to certify compliance with the safety requirements placed on electronic products. approval reference type: dg11 approval logo certificates certification body description vde approvals vde certificate number: 40048151 ul approvals ul ul file number: e96454 cqc approvals cqc ccc certificate number: pending product standards product standards that are referenced organization design standard description designed according to iec 60320-1 appliance couplers for household and similar general purposes designed according to ul 60320-1 standard for attachment plugs and receptacles designed according to csa c22.2 no. 60320-1 general use receptacles, attachment plugs, and similar wiring devices application standards application standards where the product can be used organization design standard description designed for applications acc. iec/ul 60950 iec 60950-1 includes the basic requirements for the safety of information technology equipment. compliances the product complies with following guide lines identification details initiator description ce declaration of conformity schurter ag the ce marking declares that the product complies with the applicable requirements laid down in the harmonisation of community legislation on its affixing in accordance with eu regulation 765/2008. rohs schurter ag eu directive rohs 2011/65/eu china rohs schurter ag the law sj / t 11363-2006 (china rohs) has been in force since 1 march 2007. it is similar to the eu directive rohs. reach schurter ag on 1 june 2007, regulation (ec) no 1907/2006 on the registration, evaluation, authorization and restriction of chemicals 1 (abbreviated as "reach") entered into force. micrositev-lock schurter ag v-lock system are based on a matching plug-dose combination. the connector is equipped with a notch intended for use with the latching cordset. the cord latching system prevents against accidental removal of the cordset. dimensions [mm] snap-in mounting for front mount ip40 35 63 r1.5 (51.6) 48.3 32.45 3.3 s 16 22.1 5.35 5.65 max. r3 30 0.10 59 +0.20 0 +0.10 0 s = panel thickness
3 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors screw-on mounting version a for front mount ip40 r1.5 66 76 35 32.45 1.2 ? 3.4 ? 6.2 3.3 48.3 (51.6) 16 22.1 5.65 5.35 30 0.10 66 0.10 59 +0.20 0 ? 3.4/m3 max. r3 screw-on mounting version a for rear mount ip40 ? 3.4 r1.5 66 76 35 50.1 (51.6) 34.25 1.8 1.5 5.65 5.35 16 22.1 ? 3.4/m3 66 0.10 57.2 0.10 max. r1 59.2 0.10 screw-on mounting version b for front mount ip40 5.65 5.35 22.1 16 1.2 ? 6.2 (51.6) 48.3 32.45 3.3 48 38 63 r1.5 ? 3.4 / m3 38 0.10 30 0.10 59 +0.20 0 max. r3
4 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors screw-on mounting version b for rear mount ip40 48 38 63 r1.5 ? 3.4 50.1 (51.6) 1.8 1.5 34.25 5.65 5.35 16 22.1 38 0.10 29.2 0.10 ? 3.4 / m3 max. r1 57.2 0.10 screw-on mounting for front mount ip67 38 68 51 42 16 22.1 5.65 5.35 3.3 32.45 (53.6) 50.3 34.3 0.10 42 0.10 ? 3.4/m3 max. r3 38 0.10 59 +0.20 0 diagrams l n pe pe' l' p 1 n' p 2 1) 2) ta 35 1) line 2) load effect of ambient temperature the units are calibrated for an ambient temperature of 23c. to determine the rated cur - rent for a lower or higher ambient temperature use a correction factor typical value from the table below ambient temperature [c] correction factor -30 0.76 -20 0.81 0 0.90 +23 1.00 +40 1.03 +50 1.04 +60 1.06 example: rated current = 5 a, environmental temperature = 50 c -- correction factor = 1.04, resulting current = 5.2 a -- fount to next higher rated current: 6 a
5 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors time-current-curves time in seconds ty p p ta 35 nennstro m <3 a (tc-1,tc-2) umgebungstemp. +23 c 1,05 10 8 5 4 3 2 1,35 10'000 60 2`000 1`000 500 200 100 50 20 10 [ sec ] [ min ] 10 5 1 30 20 5 2 1 0,5 0,3 0,2 0,1 multiple of rated current in reference temperature +23 time in seconds 1,05 10 8 5 4 3 2 1,35 10'000 60 2`000 1`000 500 200 100 50 20 10 [ sec [ min ] 10 5 1 30 20 5 2 1 0,5 0,3 0,2 0,1 ] > 3?15a (tc-1, tc-2) ty p ta 35 nennstro m umgebungs- temp. +23 c multiple of rated current in reference temperature +23
6 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors rated curr ent i n (a) other rated curr ents on r equest i n code 1,0 j10 2,0 j20 4,0 040 5,0 050 6,0 060 i n code 8,0 080 10,0 100 12,0 120* 15,0 150* f 120 c0 no other featur es f embossed h printed white k printed black l printed white m printed black surface illustration colour of print rocker legend l 0 on off on off l l 0 0 other legends on r equest colours switch fr ont rocker non-illuminated illuminated w black white ? b black black ? 3 black ? r ed transpar ent 4 black ? gr een transpar ent 6 black ? orange transpar ent other colours on r equest cbd w t a35- order code switch without cbt cbd illumination switch illuminated 240 v c12 c32 120 v c14 c34 other versions on r equest t able 1 selection for type t a35 or der example line load line load number of switched poles 2-pole number of pr otected poles 1 2 *) ul / csa only position of the r ocker legend e.g. i / o
7 power entry modules without line filter dg11 https://www.schurter.com /pg05 connectors t yp con? guration code (example) t a35 dg11 c b d w f 1 2 0 c 0 -000- c6135-xxx - xxx -00 see table 1 con? guration code please note that schurter will establish an inter nal part number for logistics use in addition to the or der code. the format of this inter nal part number is, for example: 3-xxx-xxx panel mounting 1) 00 scr ew version a fr ont mounting 01 scr ew version b fr ont mounting 02 scr ew version a r ear mounting 03 scr ew version b r ear mounting 10 snap-in 1.0 mm 12 snap-in 1.2 mm 15 snap-in 1.5 mm 20 snap-in 2.0 mm 25 snap-in 2.5 mm 30 snap-in 3.0 mm 88 scr ew version fr ont mounting (sealed towar ds housing, ip65) color 0 black scr ew version a scr ew version b 1) t erminal pe 0 w ithout (pcii) 1 qc 6.3x0.8 mm t erminal l 1 qc 6.3x0.8 mm (unwir ed) 3 connection to t a35 (wir ed) t erminal n 1 qc 6.3x0.8 mm (unwir ed) 3 connection to t a35 (wir ed) all variants config. code order number dg11-c126f100c0-000-c6135-331-200-00 3-107-924 dg11-cbdwm100c0-000-c6135-331-880-00 3-108-454 dg11-cbdbl100c0-000-c6135-331-010-00 3-108-463 dg11-cbdwm100c0-000-c6135-331-150-00 3-109-713 dg11-cbdwm100c0-000-c6135-331-010-00 3-109-714 dg11-cbdwm100c0-000-c6135-331-020-00 3-109-715 dg11-cbdwm150c0-000-c6135-331-150-00 3-109-716 dg11-cbdwm150c0-000-c6135-331-010-00 3-109-717 dg11-cbdwm150c0-000-c6135-331-020-00 3-109-718 dg11-cbdwm150c0-000-c6135-331-880-00 3-109-719 most popular. availability for all products can be searched real-time: https://www.schurter.com/en/stock-check/stock-check-schurter packaging unit 10 pcs the specifications, descriptions and illustrations indicated in this document are based on current information. all content is subject to modifications and amendments. information furnished is believed to be accurate and reliable. however, users should independently evaluate the suitability and test each product selected for their own applications. 23.07.2018
|
